Carbureted & EFI For Increasing Performance
High-Performance EFI Auto Repair in Austin
The expert mechanics at Austin Auto Repair know switching to fuel injection often improves the fuel efficiency and performance of older carbureted engines. In newer cars, replacing a single fuel injector with a multi-port fuel injector creates an intense, even flow of fuel on each cylinder when your engine needs it most. Feed your engine the fuel it needs with fuel pumps, fuel filters, superchargers, and turbochargers. Break out of gasoline only feed engines by adding a nitrous kit or cooling methanol injection kit.
To ensure the correct air to fuel ratio, Austin Auto Repair can add a new stock-height replacement intake manifold, cold air intake, and fuel rails. Never run rich or lean with a hood scoop, high-performance air filter, and new O2 sensor. Call Austin Auto Repair and talk to us about increasing your car's performance. When you want performance you need the auto repair experts at Austin Auto Repair located at 9324 W Hwy 290.
If you're ready to take your car or truck's fuel injection to the next level, Austin Auto Repair is ready with injectors, manifolds, fuel rails, sensors, and complete performance EFI conversion kits. From BMW to Audi to Corvette, Austin Auto Repair has you covered.
Tuning Old School Carburetors For True Muscle
Your muscle car may be starving for air! Bring it to Austin Auto Repair and find out. Because of operating losses in the intake runner and cylinder with newer unleaded fuels that do not fully vaporize in the combustion chamber, cars tuned to the manufacturer's specifications can run lean. Austin Auto Repair can diagnose if you are actually running leaner than the manufacturer suggested ratio of 14.7:1 air to fuel mixture. Bring your classic car to Austin Auto Repair at 9324 W Hwy 290 to tune the perfect air to fuel mixture and correct ignition spark for maximum power.
Today I dropped in to see if they could pull a bearing off of my RV started motor that operates my RV hydraulic jacks. I had just purchased a new motor and needed help. I was at this repair shop for a total of 20 minutes, and they were able to successfully remove the bearing from the shaft, and I was on my way. And all they asked for was a $5 or $10 tip to the young mechanic who did the job! I would return to this shop in a heartbeat. Great and nice folks.